| Hardware |
RF: 2.4 and 5 GHz frequency bands Standards: IEEE 802.11a/n/ac on 5 GHz; IEEE 802.11b/g/n on 2.4 GHz Radio I: 11b/g/n: 2.412~2.484 GHz Radio II: 11a/n/ac: 5.18-5.24 and 5.26-5.32 and 5.5-5.7 and 5.745-5.825 GHz Data Rate: Up to 1300 Mbps in 5 GHz; Up to 450 Mbps in 2.4 GHz Memory: 128 MB Flash Memory: 16 MB Power Consumption: Up to 22 W |
| Antenna Array Specifications |
Integrated 3D Sectorized Antenna Array 4 dBi on 2.4 GHz 5 dBi on 5 GHz |
| Physical Interfaces |
1 x RJ-45 Gigabit Ethernet port (10/100/1000 Mbps) 1 x Reset button 1 x Power connector |
| LED Indicators | Power, WPS, 2.4 GHz, 5 GHz, LAN |
| Power Requirements |
Power Supply: 90 to 240 VDC ± 10%, 50/60 Hz Active Ethernet: Power-over-Ethernet, IEEE 802.3at Power Adapter: 12 V / 2 A |
| Modulations |
802.11b: BPSK, QPSK, CCK 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM 802.11ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM |
| Operating Channels |
2.4 GHz: US/Canada 1-11 5 GHz: Country dependent for the following ranges: 36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, 149, 153, 157, 161, 165 |
| Software | |
|---|---|
| Topology | Infrastructure/Ad-Hoc |
| Operation Modes | Access Point, WDS Bridge, WDS Access Point |
| Multiple BSSID | Supports up to 8 BSSIDs per radio |
| LAN | IP (check validity and DHCP server IP range) MAC |
| SSID-to-VLAN Tagging | Supports 802.1q SSID-to-VLAN tagging |
| Spanning Tree | Supports 802.1d Spanning Tree Protocol |
| Wireless |
Wireless Mode: 11a/11b/11g/11n/11ac Channel selection (settings vary by country) Channel bandwidth (Auto, 20 MHz, 40 MHz) Transmission rate: 2.4 GHz: 11n only, 11b/b/n mix, 11b only, 11b/g, 11g only 5 GHz: 11n only, 11a/n mix, 11a only, 11ac only |
| QoS (Quality of Service) | WMM (Wireless Multimedia) |
| VPN | Pass-through (PPTP, L2TP, IPSec) |
| WPS | Software only |
| Management | |
|---|---|
| Tx Power Control | Adjust transmit power by dBm |
| Configuration | Web-based configuration (http)/Telnet |
| Telnet Server | CLI |
| Firmware Upgrade | Via web browser, settings are reserved after upgrade |
| Administrator Setting | Administrator Username and Password Change |
| Reset Setting |
Reboot (press 1 second) Reset to factory default (press 10 seconds) |
| System Monitoring | Status Statistic and Event Log |
| SNMP | V1, V2c, V3 |
| MIB | MIB I, MIB II (RFC1213) and private MIB |
| Traffic Shaping | Incoming and outgoing wireless traffic shaping |
| Auto Channel Selection | Automatically selecting least congested channel |
| Bandwidth Measurement | IP range and bandwidth management |
| Auto Reboot | Reboot Access Point by minute, hour, day, or week |
| Backup and Restore | Save and restore settings through Web interface |
| CLI | Supports Command Line Interface |
| Diagnosis | IP pinging statistics |
| Log | SysLog and Local Log support |
| LED Control | On/Off |
| Detection | AP Detection: Scanning for available EnGenius APs |
| Wireless / Network | PPTP: Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks |
| Wireless Security |
WPA/WPA2 Personal (WPA-PSK using TKIP or AES) WPA/WPA2 Enterprise (WPA-EAP using TKIP) 802.1X RADIUS Authenticator: MD5/TLS/TTLS, PEAP SSID broadcast enable/disable MAC Address Filtering, Up to 50 fields Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics) |
| QoS (Quality of Service) | WMM (Wireless Multimedia) |
PRODUK LAINNYA DALAM KATEGORI INI




